No internet for few weeks here, but some new things were created- and now it is getting too hot to work in the garage. I played around with laying plaster over a male aluminum figure (from my MFA) and pulling areas, along with pulling a plaster from the silicon mold
of the figure. Then I played around with introducing thin planar areas
and really just made a mess. But after all the retentive work of
pulling good figures, then centaur chickens…it was fun to get messy
for a bit.
I may come back to this process, but since then have purchased foam and a hot-wire to cut the foam. I intend to begin working at finding gesture, balance, and form that is derived from the figure- but as a direct carving process rather than playing with molds.