A quicker set today, doing only two rounds instead of three- with brown for the first round, then black, and white for the second.
One minute and two minute drawings, two rounds. I like the directness of mark making to build volume.
Our windstorm blew itself out and the day was nice enough to install/fit the passenger side aeromod. A bolt sheared off and needed drilling out and retapping- all because the hole in the plate was just out of alignment. All fixed.Tomorrow’s job is welding on a few small reinforcing triangles. Along the lower drop line is a tab bent up to connect to the flange of truck undercarriage. The weld will ensure it doesn’t shear at the bend line. This is the third point of contact (held with a stainless steel bolt, not in place here, but you can see the hole), and although minimal, offers a huge amount of stability.
