Another trip without falling.

Cement board tub-surround topped with greenboard, and drywall for the rest.
Cement board over last winter’s freeze-fix under the sink. I caulked the seams rather than mud them, for sanity mostly.
Prior to drywall it is smart to level out all the old beams by planing up the beams through addition or subtraction. This lets the drywall go up flat. A less optimal option is to float plaster and take up the difference. That’s what I’m going with.
It took awhile to overcome the old header board (that I’d left in place even though I’d pulled the ceiling) which was a bit proud, and an added anchor to the floated corner at the door (unseen here). All done in 20 minute sanding plaster, and for the final skim coat I’d brought up premix media from the SLC shop drywalling. I forgot that I’d brought it, but discovered it at the last.
I added rubberized window seal between the beams and the drywall, allowing some give.
Then it was on to painting. Just the drywall seal for now. I also experimented with covering the ceiling media in layers of paint, keeping clear of the edges / wooden beams. It worked well, so I may paint a fresh panel before cutting it, then put it up over the original layer. This would keep the beams clean and double the ceiling insulation as well.
The tub surround needs a special waterproof sealant, and about twice as much tile as I have around. The tile I have is for the woodstove and heat battery, which I’ve never had the time to put up- so I was going to use it here. Good thing it wasn’t enough media, as this isn’t where it goes anyway. I’ll hit the tile stores in SLC to find something nice.
The base of the walls around the house have a steel footing layed up with the concrete, except for this run of wall from the kitchen door and back through the bathroom. Critter highway. It is cleaned out, and a layer of the blue breathing media is pressed in then capped with wire stucco mesh.
This corner had no gutter for more than 30 years, and the concrete broke up with freeze/thaw. The concrete issues will have to wait, but I can reseal the exposed subfloor and corner beam.
Mudded up with mortar mix, similar to redux on the ice house a few years back (I wiped the wall down after the photo…)
No more access, so the new work inside should stay clean and clear.
Still a storm every night, but with just a breath of rain. Cooling us off from hitting the low 90’s, which is pretty hot for up here.
The next morning we drive home into a long headwind that spins up to oven temps of 107 in Idaho and into Utah. The little truck could only hold 70mph with the A/C on without overheating (the radiator fluid hasn’t been changed out in years…). I was worried about getting over Malad summit, but a rainstorm met us at the foot of the grade and swept us over the top and back into the heat. As we neared SLC a giant outflow hoodoo wall of dust enveloped us in a howling twilight, and soon met the driving rain of the monsoon system. We were home with a half hour of stormy driving, and temperatures had dropped to 80, falling to 70 by dawn.
1 comment
  1. Sherrie said:

    The bathroom is beautiful! Good to see you and E! xxoo

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: